Bang & Olufsen BeoLab 10 Specifications Page 1

Guide BeoLab 3

>> Adapt BeoLab 3 to your room Setup examples Here are three examples which show how to set the POSITION switch on each loudspeaker in different

3506393 0501 Printed in Denmark by Bogtrykkergården a-s, Struer This product fulfils the conditions stated in the EEU directives 89/336 and 73/23.

www.bang-olufsen.dk

Acoustic Lens Technology – manufactured under license from Sausalito Audio Works. To get access to the approval labels, remove the BeoLab 3 top cap. N

Daily use When you have fi nished setting up the loudspeakers as described on the following pages, connect the entire system to the mains. The loudspea

Setting up BeoLab 3 We recommend that you follow this procedure: – Disconnect your system from the mains. – Place the loudspeaker according to the g

abc~ 3 m (10')30 cm (12")0150 cm (60")90 cm (35")abc5For optimal sound performance make sure that the loudspeaker is directed towa

Cable connections POSITION switch This switch has three settings: FREE, WALL, and CORNER. Which setting to use is explained in ‘Adapt BeoLab 3 to your

Power LinkMk 3LEFT RIGHT1LEFT RIGHT27Power Link connections: These connections carry both the right and left sound signals. There fore, the cables may

Adapt BeoLab 3 to your room The POSITION switch When a loudspeaker is placed in a corner, the bass level is boosted compared to the bass level from a

FREEWALLCORNER~ 3 m10'~ 3 m10'9How to measure? The distances referred to, are measured as shown here (the loudspeaker seen from above). The