Bang & Olufsen BeoLab 10 Installation Guide download pdf (Page 24)

Line-in setting and log les 24

Line-in setting and log les

Via USB memory stick

The line-in settings can be changed on BeoLab Transmitter 1 by the content of a le called WPLSETUP.TXT placed on a USB memory stick.

At the same time log les can be dumped to the USB memory stick.

[File formats supported are: FAT 16, FAT32 and lenames only consisting of 8.3 characters].

The WPLSETUP.TXT le and the format for the settings can be obtained as follows:

- Insert an empty USB memory stick into the USB A connector.

The BeoLab Transmitter 1 will then create a le on the USB memory stick with the le name WPL_DUMP.TXT.

- Move the USB memory stick to a PC and using a simple text editor, the setting values can be changed according to the source product used with

the BeoLab Transmitter 1; see table below.

- Change the lename to WPLSETUP.TXT.

All lines starting with ‘;’ (semicolon) are regarded as comment lines.

- Disconnect the BeoLab Transmitter 1 from the mains for at least 60 s.

- Insert the USB memory stick into the USB A connector. (Must remain in the USB A socket for at least 60 s to ensure all logging dumped after

restart).

- Connect the BeoLab Transmitter 1 to the mains. Restart is indicated by the product status LED being solid red

- The BeoLab Transmitter 1 discovers the WPLSETUP.TXT le, and the settings for line-in are set in the BeoLab Transmitter 1.

A le named WPL_DUMP.TXT will be created on the USB memory stick; or alternatively overwrite the existing le of the same name.

If a line with the text: ERROR QUEUE PLEASE is found in the WPLSETUP.TXT le, the error log will be dumped in a le named WPLERROR.TXT when

the USB memory stick is inserted into the USB A connector.

If a line with the text: STORE DFS LOG is found in the WPLSETUP.TXT le, a log le consisting of 1000 entries (in a circle buffer) separated by

semicolon is dumped to the USB memory stick. Entries are changes in the setup of the BeoLab Transmitter 1.

All the above les are or must be located in the root folder of the USB memory stick.

Default values and ranges

Setting value Default Range

Line-in Impedance HIGH HIGH/LOW

RCA trigger level 140 mV RMS 30 to 1000 (high value results in less sensitivity)

RCA time out 900 s 0 to 2550 in steps of 10

Line-in via PL sockets same as RCA time out -

TOSLINK time out 1 s 1 to 2550 in steps of 1

RCA and TOSLINK gain: -3 dB -40 to 10

ALWAYS ON FALSE TRUE ~ connection to speakers are always on, for faster start up. Power consumption is

somewhat higher compared to standby consumption.

FALSE ~ Some start up time may be expected; standby power consumption

ERROR QUEUE PLEASE ;ERROR QUEUE PLEASE = out commented ERROR QUEUE PLEASE /

;ERROR QUEUE PLEASE

STORE DFS LOG ;STORE DFS LOG = out commented STORE DFS LOG /

;STORE DFS LOG

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Bang & Olufsen BeoLab 10 Installation Guide Page 24