Bang & Olufsen BeoLab 10 Installation Guide download pdf (Page 17)

Push button functions 17

Push button functions

State SELECT STORE Time Comment

Scan X (short) - ≤1.5 s In non-conguration mode: Scans for wireless speakers

In conguration mode: Lit Power Link LEDs to show the number of speakers found

Store default - X (short) ≤1.5 s Scanning completed: store default. Note: when SUB 2.1 is set to On, manual conguration is forced

Show Power Link channel - X (long) ≥ 1.5 s and ≤10 s Show status on Power Link LEDs (turns Off after 10 s time-out)

Manual conguration mode X (long) - ≥ 1.5 s and ≤10 s Conguration mode: Mode for manually conguring the match between the sound channel and a

speaker

Shift noise to next speaker X (short) - ≤1.5 s Conguration mode: Move emitted noise to another speaker

Finish manual conguration * X (long) ≥ 1.5 s and ≤10 s Conguration mode: Finish manual conguration whenever desired

Store - X (short) ≤1.5 s Conguration mode: Stores the conguration of the match between the sound channel and a

speaker and continue with next channel

Store * - X (long) ≥ 1.5 s and ≤10 s Conguration mode: Stores the conguration of the match between the sound channel and a

speaker and remain on same channel to be matched with another speaker

Below: Press buttons simultaneously!

Cancel X (short) X (short) ≤1.5 s Conguration mode: Move emitted noise one step back to previous sound channel to recongure an

inadvertently stored conguration

Reset association X (long) X (long) ≥ 1.5 s and ≤10 s Erase speaker mapping.

Bang & Olufsen speakers will then ash green. If not press (long) the RESET button on the speaker(s)

Factory reset X (very long) X (very long) ≥ 10 s Erase speaker mapping, and resets the settings to factory default

Bang & Olufsen speakers will then ash green. If not press (long) the RESET button on the speaker(s)

* Functions available with the SW ver. 1.1 and newer.

Note: The cancel function me be used whenever a conguration of a speaker with at sound channel is to be regretted

If the product is a BeoVision 11/BeoPlay V1 or BeoSystem 4, it is possible to press the STORE button when the scan is completed. All conguration

of the speakers can then be handled via the SPEAKER CONNECTIONS menu.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

No comments

Bang & Olufsen BeoLab 10 Installation Guide Page 17