Bang & Olufsen BeoLab 10 Installation Guide download pdf (Page 18)

LED indications 18

LED indications

Power Link LED indications

White ~ left speaker Red ~ right speaker Comment

Off Sound channel is inactive after power up

Not congured yet i.e. during manual conguration

Normal operation

On Solid light after scanning and storing; turns Off after 10 s time-out

Also shown when checking for connected speakers: long press on STORE

Flashing During manual conguration or if a speaker is not congured

WIRELESS LED indications

State Signal Time Comment

Congured wirelessly - - Product is congured wirelessly

Standby Off - Product is in standby mode

Normal operation White (solid) Off after 10 s time-out After pressing STORE: Speaker connections behave normally

Normal operation White (slow ashing) 200 ms/200 ms No speakers are connected

Connecting Green (fast ashing) 100 ms/100 ms In setup (scanning) mode and open for connecting speakers

Network strength is low Orange (solid) - Connection quality in network is low

Network failure Orange (fast ashing) 100 ms/100 ms Network error or some malfunctioning e.g. subwoofer not found in a SUB 2.1 setup

Product Status LED indications

State Signal Time Comment

Power Link Transmitter 1 is Off - - Product is switched Off

Standby Off - Product is in standby mode

Normal operation Off - Product behaves normally

Mains On and

Restart after Reset

Red (solid) Off after 10 s time-out * Lit when power is applied to the BeoLab Transmitter 1, to indicate that it is switched On and becomes

ready for operation

Also lit when reset either by the user (external) or by the BeoLab Transmitter 1 (internal)

Turning Off (go to Standby) Red (solid) Off after 10 s time-out * Lit when switching Off either via Power Link from the source product or when the signal is no longer

present (i.e. silence in 15 minutes)

Turning On Green (solid) Off after 10 s time-out * The BeoLab Transmitter 1 is switched On and has sensed an input

Software Update Green (slow ashing) 200 ms/100 ms

Off when done

Indicate that the power must not be disconnected during the update process

Product failure Orange (fast ashing) 100 ms/100 ms Hardware error - product will not revert to normal operation or if revert automatically to normal

operation : see ERROR LOG in ServiceTool

Product Status LED and WIRELESS LED indications simultaneously

State Signal Time Comment

Network strength low /

poor wireless range

Orange (solid) - System connection quality is low. Distance to speaker(s) too long

Network failure Orange (fast ashing) 100 ms/100 ms Network error or other malfunctioning

* The WIRELESS LED indicator will not go Off within time out or automatic standby mode, during the setup process.

(See page 4 and page 16)

(See page 4)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Comments to this Manuals

No comments

Bang & Olufsen BeoLab 10 Installation Guide Page 18

Comments to this Manuals

Related products and manuals for Soundbar speakers Bang & Olufsen BeoLab 10