Bang & Olufsen BeoTime User Manual download pdf (Page 32)

0: Decrease break.

1 .. 7: Decrease with step 1 to 7.

8: Increase break.

9 .. 15: Increase with step 1 to 7.

For datapoint type 3.008 (Control Blinds), the coding is similar but with Up and Down instead of Decrease and

Increase.

Importing and exporting KNX resources

KNX resources can be loaded to and exported from MLGW as a CSV (comma separated values) file. The file format is

according to RFC4180.

Valid lines in the file must contain at least 2 fields: name, group address. Optionally a third field could be added

defining the Data type.

This format is compatible with ETS3 Professional group address Export/Import 1/1 file.

Non-printable characters and reverse solidus (backslash) should be escaped. E.g. \01 for ASCII character SOH (values

are hexadecimal), \\ for backslash, \n for newline, \r for carriage return.

KNX events and commands

MLGW will generate an event whenever a group address is written to, provided the datapoint type written is 2 Bytes

or less in size.

An event can be defined for a specific value set to the group address.

Also, an event can be defined for any non-zero value set to the group address.

Commands can write to a group address any of the possible values.

Conson XP

Connection to a Conson system is done via an XP130 gateway module. This module provides an RS485 interface, so

a RS232 to RS485 converter is needed for connecting to MLGW.

Conson resources

On the device setup screen, define the modules you need to interact with. A module is identified by a module type

plus a link number. Use the monitoring tool to analyse the events on the bus.

Events and commands

Events occurring on the Conson bus are changes on a module's input. This is signaled as a circuit make or break

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 50 51

No comments

Bang & Olufsen BeoTime User Manual Page 32