Bang & Olufsen BeoTime User Manual download pdf (Page 30)

Commands

3 types of commands are supported: device, output and HVAC commands.

Device commands require a component number (see the Events section above) and can be any of the following:

Press or close

Release or open

Hold

Multi-tap

Select scene

Set LED state

Set level

Raise, Lower or Stop

Possible scene numbers are 0 (OFF) to 32.

Setting levels require a level percentage in the range 0 to 100, and a corresponding fade time.

Valid formats for fade time are SS, SS.ss, MM:SS or HH:MM:SS.

Output commands control a particular zone or output. Note that in general, an ID must have been explicitly

assigned to that zone/output during Lutron system setup.

Output commands can be:

Set level

Raise, lower or stop

Pulse

Setting levels require a level percentage in the range 0 to 100, and a corresponding fade time.

Pulsing an output requires a pulse duration.

Valid formats for fade time and pulse duration are SS, SS.ss, MM:SS or HH:MM:SS.

HVAC commands can control the following parameters:

Heat and cool setpoints

Operation mode

Fan mode

Eco mode

Schedule (follow schedule or hold)

The setpoints require a temperature. The temperature can be given in Fahrenheit or Celsius (a value less than 40 is

interpreted as Celsius, above 40 as Fahrenheit). MLGW automatically converts Celsius to Fahrenheit internally when

communicating with the Lutron system.

KNX / EIB

MLGW can interact with KNX systems by means of shared variables (group addresses). The KNX bus supported is

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 50 51

No comments

Bang & Olufsen BeoTime User Manual Page 30