Bang & Olufsen BeoLab 5 Specifications download pdf (Page 7)

Cover for socket panel: To get access to the

sockets and the RIGHT–LEFT switch, you will have

to remove the cover. To do so, pull out the bottom

edge of the cover, as illustrated above.

Cable cover: Place the mains lead and the signal

cables inside the enclosed cable cover, and then

use the special tool to seal the cover.

Cable clamp: For safety reasons the mains lead

must be secured to the loudspeaker. To do so,

place the cable cover with the cables behind the

clamp, and tighten the two screws.

The illustration to the left shows the placement

of different parts:

1 Touch field

2 Indicator light

3 High frequency speaker dome – do not touch!

4 Mid frequency speaker dome – do not touch!

5 Receiver for Beo4 remote control signals

6 Upper bass speaker unit

7 Moving microphone for the Adaptive Bass

Control system

8 Lower bass speaker unit

9 Cover for socket panel

10 Base

11 Beo4 remote control (optional accessory)

BEOLAB 5 GUIDE Pi d GB 3506377 2 PRIMA

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Bang & Olufsen BeoLab 5 Specifications Page 7