Bang & Olufsen BeoLab 5 Specifications download pdf (Page 16)

>> Use the PIN code system

If you have used the same four-digit PIN code for

all your Bang & Olufsen products, you can easily

unlock them in one step – just remember to place

yourself in a position so all units are able to

receive the Beo4 remote control signals.

The PIN code in ‘daily use’…

In daily use you will not notice the PIN code

system. However, if the loudspeaker has been

disconnected from the mains for more than

15–30 minutes (or if there has been a longer

power failure in your area) the activated PIN

code system will only allow the loudspeaker

to play for approximately five minutes before

it automatically switches to standby.

In this case, in order to unlock the

loudspeaker, you must key in your personally

chosen PIN code with a Beo4 remote control.

Should you enter a wrong PIN code, you only

have four more attempts to key in the correct

code, after which the loudspeaker is switched

off and cannot be switched on for three

hours! During these three hours the

loudspeaker must remain connected to the

mains power.

To unlock BeoLab 5

If the loudspeaker is locked by the PIN code

system the indicator light slowly flashes red and

green when you switch on.

While BeoLab 5 is playing…

> Key in your four-digit PIN code on the Beo4

remote control*.

The loudspeaker confirms each digit with a

‘beep’.

If the PIN code is accepted, the indicator light now

shines green – indicating that the loudspeaker has

been unlocked.

If the PIN code is not accepted, the loudspeaker

emits a sound signal, and you will have to start

over again with the four-digit code.

*If you make a mistake, press STOP and then start

digit entry over again.

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Bang & Olufsen BeoLab 5 Specifications Page 16