Bang & Olufsen BeoLab 4 User's Guide download pdf (Page 4)

4

BEFORE YOU START…

The BeoLab 4000 is designed

to accomodate many place-

ment alternatives and takes up

very little space. In fact, it can

be placed in a position which

suits its surroundings and your

preferred listening position.

The BeoLab 4000 can, of course,

be used in connection with your

audio system. The speaker units

are magnetically shielded and

you can safely connect a pair of

speakers to your video system

without affecting the picture

quality (you may even connect

a pair of speakers to your com-

puter system and benefit from

their exceptionally good sound

handling capabilities). The Beo-

Lab 4000 may also be used in a

surround sound system.

The BeoLab 4000s are extreme-

ly suitable for use in a link

room.

On the following two pages we

have listed a few things which

should be considered before

setting up the BeoLab 4000:

Do not connect any units in

your system to the mains, until

after you have made the other

connections (as described on

page 6 and 7).

For safety reasons, the mains

cord must be secured as ex-

plained on page 7.

The BeoLab 4000 is designed

for use in dry environments on-

ly, and for use within a tempe-

rature range of 10 – 40° C

(50 – 105° F).

When the BeoLab 4000 is

placed standing in an upright

position (or in the Base type

2037 – optional accessory) make

sure that the power switch is

at the base (i.e. the speaker will

be more stable because its

centre of gravity will be low).

In order not to impede ven-

tilation alway leave at least

1 cm (½") above the BeoLab

4000.

To support the weight of the

BeoLab 4000 always use the

correct size and type of screws

and wall plugs (depending on

the material and the construc-

tion of the wall).

If in doubt, consult your Bang

& Olufsen dealer.

Light partition walls are of-

ten constructed of gypsum

panels – known as drywall or

wall board – secured to vertical

studs. Gypsum is not a satisfac-

tory material to support the

weight of the BeoLab 4000!

You may, however, hang your

BeoLab 4000 on a gypsum wall,

but be sure to use the correct

size and type of screws.

Remember that all speakers

in a setup need a connection to

a mains outlet, and they are

designed to be left on at all

times.

When you are placing the

speakers try to ‘aim the front

cloth’ towards your preferred

listening position.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments